Manage stand orders
Select Option

LIMESS Messtechnik u. Software GmbH

Gripswaldstr. 37, 47804 Krefeld
Telephone +49 2151 3652800
Fax +49 2151 3652809

Hall map

NEWCAST 2019 hall map (Hall 14): stand B05

Fairground map

NEWCAST 2019 fairground map: Hall 14


Ralf Lichtenberger

02151 365 28 00


Please log in

You must be logged in to use matchmaking

Please log in for matchmaking

Registration is required to use the networking service and a separate registration for matchmaking. Please register for Matchmaking first.

Let's get started!

Welcome to Matchmaking. Would you like to get in touch with ?

Our range of products

Product categories

  • 03  Services
  • 03.05  Measuring and testing
  • 03.05.001  Material testing
  • 03  Services
  • 03.05  Measuring and testing
  • 03.05.003  Dimensional inspection

Dimensional inspection

Our products

Product category: Material testing

Material Testing

The force and strain ist measured during the defined specimen loading (tension, compression, torsion, bending). From these measures the force-strain-curve and stress-strain-curve are determined and material parameters like Young's Modulus, poisson number, elongation at strain and more complex values are calculated Different measurement systems are used :
The RTSS-Videoextensometer is suited for standardized and automatic test procedures and works as a real time strain sensor..
The Q400-Digital Image Correlation System measures spatially resolved strain values and the analysis is typicylly done in post processing because a large number of informations can be provided.

More Less

Product category: Material testing

Tensile test at CFRP

With Q400 measured strain distribution on a CFRP specimen with hole.

The right image shows the strain in the initial failure state of the specimen.

More Less

Product category: Material testing

Crack Propagation at CT Specimen

Q400 measures the crack propagation at a CT specimen under tensile load.

The video shows the major strain together with the recorded force.The diagram gives the crack length versus increasing force. The yellow vectors mark the rapid propagation with force reduction.

More Less

About us

Company portrait

The LIMESS Messtechnik und Software GmbH was founded in 1998 as a spin-off of the University of Karlsruhe and develops since then camera based measurement systems.

Our focus is highly accurate systems for measuring deformation and strain which are used in materials testing and component testing.
Hundreds of systems are in operation and LIMESS has become an industry leader.

Our strengths are

  • High quality products "Made in Germany"
  • The technical consulting
  • The widespread application experience
  • The uncomplicated and personal support.
  • The individual Solutions